Variations

Variations act like a toggle, with which only one element can be visible at a time. This allows you to have different versions of your product's geometry in one scene. It can be very useful in cases such as different wheels on a car, a wall that can have either a window or a door, or a phone case with different accessories.

 

Part or Group Variations

There are two ways to create Variations in your scene. You can either:

  1. Select the parts or groups you would like to turn into a Variation

  2. Click the Variations button in the Scene Tree toolbar, or right-click to open the context menu and select Make Variation

or

  1. Choose an already existing group

  2. Right-click to open the context menu and select Make Variation

 

Note that performing these steps on a model set, will result in a group variation. For instructions to create a Model Set Variation see the section below.

 

Model Set Variations

A Model Set Variation will create a Variation on Model Set level. This means that only one Model Set can be toggled visible at a time and KeyShot Studio will hide all other Model Sets in your scene. The only exception to this is a Model Set being set to Always visible.

To create a Model Set Variation

  1. Right-click on Model Sets, the top most line in the Scene Tree

  2. Select Make Model Set Variation from the context menu

Output

Variations can be added to the Queue via the Render Dialog.